ATRS Slick Side R-Lenght Build (Upper Only) (Open to Trades)

See bottom for what I'm interested in for trades :)

Build list :

• Faxon Firearms Gunner Series, Mid Lenght Gas, 11.5in barrel (5.56)
• Faxon Firearms 0.625'' Gas Block
• Lantac Nitrited Gas Tube
• Strike Industries Strike Rail 10in Rail
• A2 Birdcage Flashhider/Comp and Standard AR Dust Cover
• *******************************************
• Feyachi V30 2MOA Red dot (Held up fine on the 308 gun I had it on) (Currently removed from upper)
• Magpul MLOK AFG - FDE
• Magpul Type 1 Rail covers - FDE

Upper was built from leftover parts I had laying around from previous guns, has not been test fired or assembled on a lower but everything gauged properly and the headspace was checked and was good, it was a blem receiver when I bought it and shows a couple marks here or there but nothing that could affect functionality (See picture #6 for the worst damage). Barrel nut had to be slightly modified to allow the gas tube to pass the cutouts when properly torqued, but that's mainly shitty design from the SI Barrel Nut, doesn't affect reliability or safety, no pressure bearing components were modified. Has been hand cycled with my bolt and charging handle to check fitment, so it shows a few marks from that.

I also have a BCM Sopmod stock and a BCM Gunfighter Mod 2 Grip, both in FDE, that can be worked into the deal if you're interested, both were assembled on my personal NR ATRS but I switched to black furniture, so they're brand new but don't come with packaging (see last picture). I believe I also have an AR15 Upper vice block that could be included, but would need to be slightly modified to work on the ATRS plateform.

-Included in the sale is the barrel nut wrench, a 3d printed spare brass deflector and shipping to non remote regions.

5th picture shows the rifle roughly mounted on my lower, lower is not for sale, does not include a charging handle or bolt carrier, you'll need to source one yourself.

**PAL not required for this sale as it's only the upper, if assembled on a lower it will need to be registered by the person that assembles it as a restricted firearm.

----------------------------

Trades :

• Reloading components/setup
• Antique centerfire revolver, 455 preferred
• G17 Gen 3 Spare parts, I'm looking for an aftermarket slide that can accept red dots
• Elcan SpecterDR 1x/4x in 5.56 - I'd be willing to do direct trade on this
• Try your gun trades too, worst I could say is no